Copper Cable Anti-Theft Device

The COPPER KEEPER method of wire “locking” is simple but effective. The wires are inserted into the pockets in the rubber stopper. The stopper is then inserted into the conduit. Once in place, the compression bolt is tightened. As the proper torque is approached, the rubber stopper is compressed against the conduit and wires. This prevents the wires from being easily pulled through the conduit, thus “locking” the wires in place. The Copper Keeper has four wire pockets in which wire is to be inserted. A reducing sleeve is provided to accommodate a larger range of wire sizes. If the conduit has fewer wires than stopper pockets, a plug is provided to fill the unused pocket. Multiple small wires - whose combined diameter equals the single conductor - may be retained in a single pocket Once

COPPER KEEPERS are installed in each opening of the conduit, the wire is “locked” in place preventing the easy removal. Resistances of over 150 pounds pull can be obtained by the proper installation of Copper Keepers.

COPPER KEEPERS, when installed makes an almost water tight seal, keeping out dirt and other debris that enter the conduit when “duct seal” is used.

The Copper Keeper is designed to allow removal by authorized personnel using a security keyed socket tool.

The Copper Keeper is constructed of SBR rubber, 360 aluminum and stainless steel. These materials are rust proof for years.